Posted by Brian Levantine on February 04, 2004 at 09:57:02:
In Reply to: CFAM setup question posted by Tom Fulton on February 04, 2004 at 09:32:20:
Looks good Tom. In your .ini file, you'll also need to re-designate your directories as type 'C'. Also, there is a problem with the installation of CfamNetServe.Exe (CNS) which provides remote connectivity to CFileSrv for CFAM clients. It is not installing properly from the installation program but can be manually installed using the following steps:
This procedure assumes that CometServerProducts.Exe was already run and the server programs were already installed into a designated "Comet Servers" folder.
1. Create a shortcut to CfamNetServe.Exe in the same "Comet Servers" folder as the program.
2. Rename the shortcut "Register CNS" (or whatever).
3. Add to the shortcut command line " -RegServer"
4. Run the shortcut one time.
5. Reboot your system.
To verify that CNS is running you simply open the CFileSrv console from the system tray (or Control Panel). To the right of "Remote CFAM Users [0] you should see "(Running)". If you see "(Inactive)" then the service did not start and you should contact me.