Posted by Gerry B on November 19, 2010 at 09:10:28:
Using the latest of all Comet on this new Server 2008.
Is there a way to "suppress a form feed" using a Windows Tractor Feed Epson LQ-2170 printer?
The form is 3.5 inches in height and 15 inches wide.
The customer is moving towards Lazer Forms, but until then.
The printer and/or Windows will not allow the use of a predefined form of 3.5 inches in the Windows Print definitions.
I would like to perform a "line-up" pattern and print just one(1) form.
I have used the FLUSH mnemonic or CLOSE/OPEN on Laser Printer in the past, but on this Tractor Feed printer this causes a Form Feed.
With a minimum form height of 4.0 inches.
I can and do use (LF) & (CR) controls, but the only way to get the "line-up", is to perform FLUSH or CLOSE & OPEN on the printer.
Any ideas?
Each file can be a maximum of 1MB in length Uploaded files will be purged from the server on a regular basis.