Posted by Jim Guerber on July 15, 2011 at 08:11:38:
In Reply to: Comet32/CosP error posted by Grant Foraker on July 14, 2011 at 14:23:33:
I see the logic behind you assumption that it is cosp at fault here, but the crash is in cos32.
My question is, when you selected a question mark printer, did the dialog come up or not?
The next question is, does the printer use a DES program, and if so, is it compiled in comet16 or 32?
Does this happen with every printer you care to select?
The error points us to the run statement. Perhaps the program never really started?
Which program crashes, -GFL or -GFL1?
We will be releasing build 444 today. Could you try the same scenario with it?
Each file can be a maximum of 1MB in length Uploaded files will be purged from the server on a regular basis.