Posted by Bob A on September 13, 2011 at 07:17:05: Uploaded files: 1
Is there anything visible in the attached section of the .INI file that would explain the following problem with accessing session T18?
I rarely need anything but T17 on the PROD system, since I have 5 terminals on the TEST system.
But, periodically I need multiple terminals on PROD. when I click on the icon to start the second terminal (T18) it always fails with:
COSW has encountered a problem and needs to close
what is wierd is the following:
If I click "DON'T SEND" and then try it again it will always fail and I'll never get out of the loop.
HOWEVER, if I click the icon to load COMET again, while the message is on the screen, T19 will load. Additionally, if I click the icon again,while the message is on the screen, I'll be able to load T20
Just can't seem to load T18 (not once in 2 years)
Since I'm getting "geared up" to bring the TEST system and then the PROD system up to Comet32... just figured I'd try to get to the bottom of this now.
finally... don't have any of these problems over on the TEST system... all 5 of my terminals load whenever I try.
Thanx
Bob "A"
Each file can be a maximum of 1MB in length Uploaded files will be purged from the server on a regular basis.