Posted by Bob A on August 06, 2014 at 07:23:36:
In Reply to: Re: Any ideas on enhancing successful completion of KeyBuild posted by Barbara Brazil on August 05, 2014 at 09:27:29:
I always use Record # when rebuilding....
after almost a full work day, I finally got the following output:
Comet Key Build Utility Version 13.00 08/05/2014 09:35
Input file: RCVHIST on SYS
Output file: RCVHISBK on SYS
Records written: 49924817, Time completed: 16:11
My assessment is as follows:
the progress bar cycles thru only once
after the first cycle there's no progress bar but everything is still running just fine (just that I can't see that)
after a long time (in this case 6h36) the KeyBuild ends and reports the audit trail (time and record count)
so... if there were some re-cycling of the progress bar until the process ends, there'd be no question whether or not the program is running or has crashed.
In the end... all was running fine, just couldn't establish this fact.
Post a Followup
Each file can be a maximum of 1MB in length Uploaded files will be purged from the server on a regular basis.