Posted by Marc Shevick on March 20, 2005 at 12:13:04:
I've been doing more work using the document= for assigning names and directing the output. I've noticed a couple of issues. By using the document= instruction, it does successfully use the name I assigned into the designated folder, however, the name that appears in the document manager is the generic name that would normally be assigned if the document = instruction was not used - ie. file name in folder pdf is CFC0503200.pdf. However in the document manager it shows the program name followed by (t00) - RCM270C (T01) etc.
Another issue I noticed is, for example, you run a job (ie invoices) and no invoices are generated the closing of the printer lun takes from 30 seconds to 3 minutes. I am using all CFAM. I am using the latest c2005.354, rel 0503.