Posted by Brian Levantine on April 15, 2004 at 15:46:43:
In Reply to: Toggling from ploting to LF mode on laser printer posted by Bo Gorrell on April 15, 2004 at 11:22:21:
Hi Bo. Internally there is no connection between the standard CRLF prints and the Windows GDI x,y functions. If you want to print a form and then fill it in, you should perform all of your form drawing first using GDI and then you can space down using CRLF (you can use the LINESPACING mnemonic to fine tune the line spacing). If you find youself needing to go back and forth in the same program then I would recommend using ONLY the GDI technique.